Home > Products Center > Products List > NE1617

NE1617 Datasheet PDF

Table of contents: Description Typical Application Maximum Ratings Features Pinout/Connection Diagram Related Models Datasheet

NE1617 Product Image

See larger image

Part Number：
NE1617
Category：
--
Vendor：
PHILIPS
Package Cooled：
SOP
D/C：
--
Description：
Temperature monitor for microprocessor systems

Price Break
--
Unit Price
--
Extended Price
--

NE1617.pdf

File Size: 162.09KB

File page: 16

Philips Semiconductors

(All prices are in USD) Prices for reference only
How to buy?

How long will receive a response.

supplier

Models Number

Mfg

Pack

D/C

Description

Inquire

Send your message to supplier

	Part Number	Quantity

	Country/Region	Email

	Description
	Company: Contact: Telephone: MSN: Requirements:

Description

The NE1617 is an accurate two-channel temperature monitor. It measures the temperature of itself and the temperature of a remote sensor. The remote sensor is a diode connected transistor. This can be in the form of either a discrete NPN/PNP, such as the 2N3904/2N3906, or a diode connected PNP built into another die, such as is done on some INTEL microprocessors.

The temperature of both the remote and local sensors is stored in a register that can be read via a 2-wire SMBus. The temperatures are updated at a rate that is programmable via the SMBus (the average supply current is dependent upon the update rate—the faster the rate, the higher the current).

In addition to the normal operation, which is to update the temperature at the programmed rate, there is a one shot mode that will force a temperature update.

There is also an alarm that senses either an over or under temperature condition. The trip points for this alarm are also programmable.

The device can have 1 of 9 addresses (determined by 2 address pins), so there can be up to 9 of the NE1617 on the SMBus.

It can also be put in a standby mode (in order to save power). This can be done either with software (over the SMBus) or with hardware (using the STANDBY pin).

Features

• Replacement for Maxim MAX1617 and Analog Devices ADM1021
• Monitors local and remote temperature
• Accuracy
– ± 2℃ local (on-chip) sensor
– ± 3℃ remote sensor
• No calibration required
• Programmable over/under temperature alarm
• SMBus 2-wire serial interface
• 3V to 5.5V supply range
• 70ma supply current in operating mode
• 3ma (typical) supply current in standby mode
• Small 16–lead QSOP package

Maximum Ratings

PARAMETER	MIN.	MAX.	UNIT
VDD to GND	–0.3	+6	V
D+, ADD0, ADD1	–0.3	VDD+0.3	V
D– to GND	–0.3	+0.8	V
SCLK, SDATA, ALERT, STBY	–0.3	+6	V
Input current SDATA	–1	+50	mA
D– current		±1	mA
Operating temperature range	0	+120	℃
Maximum junction temperature		+150	℃
Storage temperature range	–65	+150	℃